Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE END BITS AND CUTTING EDGES WARNING 4 - 34 It is dangerous if the work e quipment moves during t he turning o Set t he work equipment in a stable condition, set the work equipm ent lock lever to the LOCK pos ition, then stop the engin Reverse or replace the e nd bits and cutting edg es before i t is wor n out to the blade en 1. Raise the blade to a proper height, position a block un der the frame to prevent the blade from falling 2. Operate the work eq uipment lock lever to th e LOCK p osition. If the cutting edge an d the end bit on both s ides are w orn out, replace with new on If the mounting surfa ce is worn, correct it be fore turnin 3.

Loosen nut (1) and r emove bolt (2). Then r emove the cutting edge and the end bit and clean the mountin g surface. 4. Reverse or replace th e cutting edge and the end bit whe n worn out. If bolt (1) and nut (2) a re damaged, replace th em with ne w ones at he blade, then tighten partially. Drop the 5. blade three to five tim es on to the ground or r ock to rem ove any play in bolt (2), then tighten it to the correct tightening torque. When installing end bit (3), put top surface ( 4) of the en d bit in close contact with st opper (5), then tighten with the bo Tightening torque: 6 28 ± 79 Nm (64 ± 8 kgm , 462 ± 57 6. After several hours o f running, retourque th