. MAINTENANCE SERVICE PROCEDURE CHECK LEVEL OF BATTERY ELECTROLYTE Carry out this procedure before operating the machine. WARNING UPPER LEVEL line. If the Open battery cover on the left side of the machine. 2. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (1) and add distilled water to the U.L line. 3. After adding distilled water, tighten cap (1) securely. REMARK If distilled water is added to above the U.L. line, use a syringe to lower the level to the U.L. line. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker.
4 - 50 Do not use the battery if the bat tery electrolyte level is below the LOWER LEVEL line. This will accele inside of the battery and reduce the service life of the battery. In addition , it may cause an explosion. The battery generates flammabl e gas and there is danger of explosion, d o not bring fire or sparks ne Battery electrolyte is dangerous . If it gets in your eyes or on your skin, w ash it off with a large amoun doctor.
When adding distilled water to the battery, do not allow the battery electrolyte to go above the UP electrolyte level is too high, it m ay leak and cause damage to the paint s urface or corrode other parts NOTICE If there is a fear that the battery wat er may freeze after refilling with purified wa ter (e.g. commercially availa for a battery), do the replenishmen t before the day's work on the next day. Inspect the battery electrolyte l evel at least once a month and follo w the basic safety proced WHEN CHECKING ELECTROLYTE LEVEL FROM SIDE OF BATTERY tery, check as follows. If it is possible to check the ele ctrolyte level from the side of the bat tery,