OPERATION 3.10 STARTING THE ENGINE 3.10.2 ENGINE WARM-UP After starting let the engine run for a warm-up period before increasing the engine speed. This is necessary to avoid piston and bearing seizure. Refer to the engine operation and maintenance manual for more information. 3.10.3 HYDRAULIC OIL WARM-UP On machines WITHOUT hydraulic oil pre-heating system: DO NOT start the engine if the ambient temperature (oil tem- perature) is below the starting temperature shown in column "1" of the hydraulic oil viscosity chart in this section. On machines WITH hydraulic oil pre-heating system:
Before starting the engine, warm-up the hydraulic oil to the starting temperature shown in column "1" of the hydraulic oil viscosity chart. REMARK With hydraulic oil too cold, corresponding messages will be displayed on the health monitor (3). Follow the instructions given by message text. The Shovel is equipped with a ”Ѕ Qmax control circuit for cold oil” which limits the main pumps oil delivery to approximately 50% of the total capacity as long as the oil temperature has not reached the minimum operating temperature shown in column ”2” of the Viscosity and Temperature Chart on next page.
The pumps will move to maximum delivery position as soon as the minimum operating temperature of the hydraulic oil is obtained. During the warm-up period, complete several operating cycles of all hydraulic movements without load. Avoid operation against limit stops. (high pressure build up). Work can be started when the minimum operating temperature shown in column ”2” of the viscosity chart is obtained. 191 CAUTION CAUTION