MAN — Checking axial and radial clearance of turbocharger rotor shaft

Checking axial and radial clearance of turbocharger rotor shaft D Remove turbocharger, see page 98 Fig. 1 Mark turbine housing relative to the bearing hous- ing and remove turbine housing. Axial clearance Fig. 2 Remove turbocharger. Mark turbine housing rela- tive to the bearing housing and remove turbine housing. 1 Apply dial gauge holder and dial gauge under pre- load to shaft end face of the turbine wheel as shown. Press rotor shaft against dial gauge. Read and note down value. Push rotor in opposite direction. Read and note down value. The difference between the two is the axial play. Change turbocharger if axial clearance is ex- ceeded. Radial clearance Fig.

3 Radial clearance is measured only on turbine end with dial gauge or feeler gauge. 2 Apply dial gauge tip to side of hub. Push turbine wheel towards dial gauge. Read and note down value. Push turbine wheel in opposite direction. Read and note down value. The difference between the val- ues is the radial clearance. Place turbine housing in position, observe mark- ings and screw on turbine housing. 3 100