MAN — Setting valve clearance

Setting valve clearance Fig. 1 Remove cylinder head cover. Note: On engines recently manufactured the valve covers are fastened with Torx bolts for which an E12 − Ѕ ” wrench is required. 1 Fig. 2 Turn engine with engine cranking device until the piston in the cylinder to be set is at TDC (Top Dead Centre). At this point both inlet and exhaust valves will be open i. e. valves overlap. Note: As far as possible turn engine only in direction of rotation (anti-clockwise as seen when looking at the flywheel) in order to prevent the direction of rotation of the raw water pump impeller being reversed. 2 Fig.

3 D 2848 LE 403 / LE 405 Valves are in crossover in cylinder 5 1 6 2 Set valves in the cylinder 8 7654 3 21 7 3 8 4 3 Fig. 4 D 2840 LE 403 Valves are in crossover in cylinder 6 1 7 2 Set valves in the cylinder 8 9 10 876 5432 1 3 9 4 10 5 4 109 1 5 7 2 6 3 4 8 6 3 4 8 1 5 7 2 1 6 5 10 2 7 3 8 4 9 7 3 8 4 9 1 6 5 10 2