Removing and installing valve guides D For removing and installing cylinder head, see page 104 D For removing and installing valves, see page 112 Fig. 1 Press valve guide out of the combustion chamber side using pressing mandrel (special tool, see page 169, item 20). Oil new valve guide and drive/press it into the cyl- inder head using pressing mandrel and spacer sleeve (special tool). 1 Fig. 2 The valve guides vary only in length. 1 Inlet = long guide 2 Exhaust = short guide 3 Press-in depth (see publication “Engineering S Data S Setting values”). 3 2 1 The correct press-in depth is obtained by using the spacer sleeve. Afterwards ream valve guide to specified dimension. Note:
When the valve guides have been changed, the valve seats too must be re- worked (see technical data and manufac- turers’ instructions for valve seat lathes found in individual workshops). 2 115