MAN — Checking compression

Checking compression D Check valve clearance and adjust, if necessary, see page 109 D Let engine warm up D Remove all fuel injectors, see page 40 D For compression guideline values, see publica- tion “Engineering S Data S Setting values” Fig. 1 Start with 1st cylinder. Insert new seal, screw on test connection of compression recorder with union nut and tighten with pin spanner. Insert test sheet into compression recorder for Die- sel engines. Screw compression recorder on to test connection. 1 Turn engine over with starter until needle deflection of compression recorder stops, at the same time holding adjusting lever of injection pump in stop position.

Connect up compression recorder with test con- nection to the next cylinder, and check all cylinders as described above. Fig. 2 Depending on the compression recorder design, the engine can also be started directly by the com- pression recorder. For this purpose the electrical connections on the starter electromagnetic switch (terminals 50 and 30) are to be accordingly connected up. 2 Fig. 3 Compare the values measured and remove com- pression recorder and test connection. Apply “Never Seeze” to contact faces on fuel injectors. 3 Fig. 4 Screw in fuel injectors with nozzle and new seal. Screw on union nut and tighten to specified torque (see “Engineering S Data S Setting values”).

Connect up injection lines and leakage fuel return lines. 4 122