Removing and installing timing case Removing timing case Remove: D Starter, see page 145 D Flywheel, see page 87 D Fuel filter, see page 35 D Raw-water pump, see page 73 D Hydraulic pump if fitted D Bracket for exhaust manifold D Engine mounts if fitted Fig. 1 1 There are oil and coolant lines, brackets etc fitted to the timing case. These items must be removed. Note: To facilitate reassembly, memorise, note down in a drawing or take a photo of the position of the brackets, pipe clamps, spacer sleeves etc. Remove timing case cover (13 mm). Fig. 2 Remove mounting bolts from timing case (17 mm). 2 Fig. 3 The timing case is bolted to the oil pan at the bottom.
Remove all bolts from oil pan (13 mm). 3 Fig. 4 Danger: The timing case is heavy. Replace two opposite bolts with guide pins M12 x 1.5 А if necessary. 2 1 1 Two long M10 bolts Б screwed into the dead-end holes in the flange-on face facilitate handling the timing case. 4 123