MAN — Removing and installing timing case

Removing and installing timing case Fig. 5 Remove timing case. 5 Installing timing case Fig. 6 Clean contact face on crankcase of sealing resi- dues. Fit a new seal, sticking it on with a small amount of grease if necessary. Guide timing case on to the alignment pins and bolt it into place. 6 Fig. 7 Tighten bolts to specified torque. Note: Observe the different thread sizes when tightening the screws: 10 bihexagonal bolts (M12, 17 mm) and 2 hexagonal bolts (M10, 17 mm). Tighten oil pan mounting bolts. 7 Fig. 8 Remove seal residues from sealing face of timing case cover. Screw on timing case cover with new seal. Fit the oil and coolant lines. Refit all components previously removed. 8 124