MAN — Removing and installing camshaft

Removing and installing camshaft Removing camshaft D Drain coolant, see page 49 D Remove oilpan, see page 76 D Remove starter, see page 145 D Remove flywheel and timing case, see page 123 D Remove the rocker arms and take out the push rods, see page 104 Note: For removing the camshaft the engine must be turned by 180 _ . For this reason the engine must be placed on a dolly. 1 Fig. 1 Turn engine upside down so that the valve tappets do not obstruct removal of camshaft. Pull out camshaft, taking care not to damage the camshaft bearings. Check camshaft for wear and damage. Fig. 2 Remove valve tappets and check them for wear, changing them if necessary.

The valve tappets can be removed only after removal of the camshaft. 2 Fig. 3 Remove camshaft bearing bushes with suitable mandrel and drive in new bushes. Ensure that the oil supply bores are in correct position. Note: The axial camshaft stop is located behind the last camshaft bearing bush on the tim- ing case side. Owing to the helical gearing of the drive gear, the camshaft is always pulled against this stop. 3 Fig. 4 Note: D 2842 LE 404 are equipped with an injec- tion timer integrated in the camshaft gear. A pre-assembled unit consisting of a cam- shaft, a shrunk−on camshaft gear and an injection timer is available as a replace- ment. 4 125