MAN — Removing and installing crankshaft

Removing and installing crankshaft Removing crankshaft D Remove oil pan, see page 76 D Remove oil pump, see page 76 D Remove timing case, see page 123 D Remove front cover of crankshaft seal, see page 82 D Remove all pistons with connecting rods, see page 134 Fig. 1 Remove bolts from connecting rod bearing caps, take out connecting rods with pistons and arrange them in order of installation. 1 Fig. 2 Remove horizontal bolts from crankshaft bearing caps. Note: Crankshaft bearing no. 1 is located on the non-flywheel end. 2 Fig. 3 Loosen and remove mounting bolts from crank- shaft bearing caps in stages from the inside out. Take off bearing caps and arrange them in order of installation.

Take the bearing shells out of the crankcase and put them aside, arranging them in the sequence of installation. Clean the parts and check them for wear, if necessary exchanging them. 3 Fig. 4 Lift out crankshaft. Caution: Do not damage the rolling surfaces of the crankshaft bearing pins. Take bearing shells out of the crankcase and use electric marker to matchmark them with the same numbers as the bearing caps, unless they are al- ready marked. Clean parts and check for wear, replacing them if necessary. 4 131