Removing and installing crankshaft Checking spread of bearing shells Fig. 5 Position bearing shells together on flat surface. Measure and note down spread dimensions “A” and “B”. B Spread dimension = A − B A Installing crankshaft 5 Fig. 6 Clean oil ducts in crankcase and in crankshaft with dry compressed air. Thoroughly clean bearing shells and bearing journals. Install bearing shells in crankcase, observing the numbering. Caution: Observe relevant repair stage when using new bearing shells. Fig. 7 6 Apply oil to the running surfaces on the bearing shells and install crankcase, ensuring that the markings on the crankshaft and camshaft gears coincide. Fig.
8 Reassemble bearing caps with associated bearing shells. Insert vertical bearing cap screws and tighten to specified torque in stages from the inside out (see “Engineering S Data S Setting values”). Tighten finally by angle. Insert horizontal crankshaft bearing cap screws and tighten to specified torque. 7 Caution: As replacement for the lateral crankshaft bearing cap bolts now use only collar bolts 51.90020−0382 (M12x1.5x85, 12.9). Previously used bolts of other types must be replaced by these bolts. Check to see that crankshaft runs smoothly. Caution: Faulty bearing caps cannot be replaced singly. 8 132