Removing and installing crankshaft Checking axial clearance Figs. 9 and 10 Note: The axial clearance of the crankshaft de- pends on the crankshaft bearing at the fly- wheel end (thrust bearing). D Fit dial gauge holder with dial gauge to crank- case. D Move crankshaft in axial direction to and fro and read off clearance on dial gauge. D If permissible axial clearance is exceeded, re- place main bearing shells complete. 9 Fig. 11 Measure connecting rod bearing, insert pistons with connecting rod. Coat connecting rod bearing shells with oil and pull connecting rods to bearing pin. Mount connecting rod bearing caps with bearing shells (observe marking - numbers must be on the same side).
Screw in mounting bolts and tighten in stages to specified torque. Tighten finally by angle. 10 (For tightening torques and reusability of bolts, see “Engineering S Data S Setting values”.) 11 133