Removing and installing piston with connecting rod Removing piston with connecting rod D Remove oil pan, see page 76 D Remove cylinder heads, see page 104 Fig. 1 Remove bolts from connecting rod bearing cap. Fig. 2 Take off connecting rod bearing caps with bearing shells, expediting the procedure by means of light strokes with a synthetic hammer if necessary. 1 Note: Connecting rod bearing caps are match- marked with the connecting rod big ends; arrange them in corresponding order. 2 Fig. 3 Remove combustion residues (oil carbon) from top cylinder edge using a piece of hard wood. Caution: Do not damage cylinder liners. Push out connecting rod with piston in upward direction. Caution:
Do not damage oil spray nozzles. 3 Fig. 4 Lay pistons with connecting rods and associated caps aside; use deposit rack if available. Inspect pistons and piston rings visually. Note: For reworked crankcase sealing faces there are repair pistons with compression height undersizes of 0.2, 0.4 and 0.6 mm (see “Engineering S Data and S Setting va- lues”). 4 134