MAN — Removing and installing piston with connecting rod

Removing and installing piston with connecting rod Installing piston with connecting rod Note: For reworked crankcase sealing faces re- pair pistons with undersizes of 0.2, 0.4 and 0.6 mm in the compression height are available (see “Engineering S Data S Set- ting values”). Fig. 5 Check bearing shells for wear and damage. Measure spread. Install new bearing shells if necessary. When repairing connecting rod bearing journals, use bearing shells of the corresponding repair stage. 5 Fig. 6 Insert bearing shells into the connecting rods or connecting rod bearing caps. Caution: The rod shell has a red mark on the side and a brown reverse side. The top coat must not be damaged.

Apply a thin coat of oil to the connecting rod bear- ing shells. 6 Fig. 7 Apply a thin coat of oil to the cylinder liners and pistons. Arrange piston ring gaps with an offset of approx. 120 _ . Apply piston ring tightener and tighten piston rings. 7 Fig. 8 Guide connecting rod and insert piston until con- necting rod big end contacts the connecting rod bearing journal. Caution: Do not damage oil spray nozzles. 8 135