MAN — Removing and installing piston with connecting rod

Removing and installing piston with connecting rod Fig. 9 The arrow on the top of the piston must always point towards the engine centre, i. e. towards the injection pump. 9 Fig. 10 Put connecting rod bearing caps in place. Caution: The numbers on the connecting rod bea- ring cap and connecting rod big end must be on one side. 10 Fig. 11 Screw in connecting rod bearing bolts and tighten them in stages to specified value. Tighten finally by angle. (For tightening torques and reusability of bolts, see “Engineering, Data, Setting values”.) 11 Fig. 12 Slowly turn engine over. Connecting rods and oil spray nozzles (arrow) must not collide or grind against each other. Note:

As far as possible turn engine only in direction of rotation (anti-clockwise as seen when looking at the flywheel) in order to prevent the direction of rotation of the raw water pump impeller being reversed. 12 136