Removing, installing and changing piston rings Piston ring arrangement Fig. 1 1 Compression ring (double-sided keystone ring) 2 Compression ring (tapered compression ring) 3 Oil scraper ring (bevelled-edge ring) 1 2 3 1 Removing piston rings Fig. 2 Remove piston with connecting rod. Clamp connecting rod in a vice using soft jaws. Adjust piston ring pliers to piston diameter. 2 Fig. 3 Apply piston ring pliers at piston ring gap and unclip piston rings from piston ring grooves. Note: Owing to the hose-type spring the oil scra- per ring has a higher tangential tension. Carefully clean the piston ring grooves using a piece of wood. Do not damage the piston ring grooves. 3 Checking ring gap Fig.
4 Insert piston rings singly into the cylinder and as- certain the ring gap using a feeler gauge. Replace piston rings if the ring gap is too large. For ring gap see “Engineering S Data S Setting val- ues”. 4 139