Removing and installing power take-off for raw-water pump Removing power take-off for raw-water pump D Remove raw−water pump, see page 73 D Remove timing case, see page 123 Fig. 1 To remove the drive wheel from the raw-water pump (arrow), the drive shaft must be held station- ary. 1 Fig. 2 To hold drive shaft stationary, we recommend welding a spare coupling sleeve on to a suitable square-section bar so that the coupling sleeve can be held in a vice. To protect the stud bolts projecting from the timing case, ensure that the coupling sleeve is at least 30 mm above the vice. 2 Fig. 3 Plug the splined section end of the drive shaft into the coupling sleeve. Bend open caulked collar of nut.
3 Fig. 4 Remove nut from shaft. 4 150