V-belts Tensioning and changing V-belts for water pump drive Fig. 5 D Loosen mounting bolts А D Loosen lock nut Б 1 2 5 Fig. 6 D Turn adjusting nut until the V-belt is correctly tensioned. D Retighten lock nut and mounting bolts. To change the V-belts, turn adjusting nut back and swing tension pulley inwards. 6 Tensioning and changing V-belts for alternator drive Bild 7 Remove mounting bolt from tensioning pulley. 7 Bild 8 Adjust setting screw until V−belt is tensioned cor- rectly. To change V-belt, back off setting screw and push tensioning pulley downwards as far as possible. Turn engine over and let V-belt run off the V−belt pulley. Note:
As far as possible turn engine only in direction of rotation (anti-clockwise as seen when looking at the flywheel) in order to prevent the direction of rotation of the raw water pump impeller being reversed. 8 149