MAN — V-belts

V-belts Checking condition Fig. 1 D Check V-belts for cracks, oiling, overheating and wear. D Change damaged V-belts. 1 Checking tension 1 Figs. 2 and 3 Use belt tension indicator to check V-belt tension. D Lower the gauge arm А in the scale. D Position the tension indicator in the centre of the belt between the two pulleys so that the edge of the stop face Б locates against the side of the belt. D Slowly depress the pressure pad В vertically downwards until the spring disengages with an audible click; the gauge arm moves upwards. 2 3 A false reading will be obtained if you continue to apply pressure after the spring has disengaged. 2 3 Fig.

4 Taking tension reading D The tension is shown where the top of the gauge arm А intersects the kg scale. D Ensure that the gauge arm does not move be- fore you take the reading. If the reading does not correspond with the speci- fied value, the V-belt tension must be corrected. 4 148 V-belt width Tensioning forces as per kg scale on the indicator for newly fitted assembly for mainte- nance af- ter prolon- ged pe- riods of operation after as- sembly after a running time of 10 min. 2/3VX 90−100 70−80 60