Removing and installing injection pump Fig. 10 Insert injection pump so that the mounting bolts can be screwed in by hand. Check distance between injection pump and crank- case. 10 Fig. 11 Tighten the mounting bolts to specified torque (see “Engineering S Data S Setting values”). 11 Fig. 12 Apply an initial torque of 5 Nm to all mounting bolts of the gear. For this purpose two full engine revol- utions are necessary. Note: Use only M8x22 mounting bolts (property class 12.9). Now tighten all mounting bolts to 38 Nm. Check start of delivery, if necessary readjusting it (see page 27). Screw screw plug into timing case and fit timing case cover. 12 Caution:
Comply with instructions for masking unions on pressurised oil and fuel pipes (see page 3). 38