MAN — Removing and installing thermostats and water pump

Removing and installing thermostats and water pump Fig. 4 Fit water pump. Insert thermostats with new seals. 4 Fig. 5 Fit coolant elbow and cover of the fluid-cooled ex- haust pipe with new seals. Fit exchanger, see page 61. Fill up with coolant, see page 50. Refit and tension V-belt, see page 149. Note: The ratio of mixture water to antifreeze must be reestablished. See publication “Fuels, Lubricants, Coolants for Industrial and Marine Diesel Engines”. 5 Note: Exchange or repair water pump only if it has been found to be leaky For design-related reasons small quantities of coolant may permeate through the mechanical seal on the water pump.

This permeating coolant leaves a trace below the drain bore on the water pump. The water pump need not be exchanged or repaired because of this trace of permeating coolant. For this reason before exchanging or repairing a water pump ascertain D whether the coolant circuit shows visible and recurrent loss of water; if so D whether the loss of water is caused by coolant emerging from the expansion tank (e.g. over- filled) or by other leaks on hoses, etc. Water pumps must be exchanged only if water drips visibly while the engine is in operation or after the engine has been switched off. 53