MAN — Cleaning cooling system

Cleaning cooling system Cleaning the inside of the cooling system Investigations have shown that in many cases the poor condition of the coolant and / or the cooling system accounts for damage to the water pump mechanical seal. The poor condition of the cooling system is nor- mally due to use of unsuitable or no anti-freezing agents and corrosion inhibitor or defect, not early enough replaced covers for filler neck and working valves.

If twice in a short time the water pump of an engine develops leakes or the coolant is heavily contaminated (dull, brown, mechanically contaminated, grey or black signs of a leakage on the water pump casing, after the defect on the oil cooler) clean the cooling system prior to removing that water pump as follows: a) Drain coolant b) Open thermostats positively (use short-circuit inserts), so that the entire coolant circuit is flushed in the cleaning operation c) Fill coolant circuit with a mixture of hot water (min. 50 ° C) and Henkel P 3 neutrasel 5265 detergent (1.5% by volume) (-5266, -5225, Kluthe Hakopur 316), refer to Publication ”Fuels, Lubricants ...” d) Warm up engine under load.

After a temperature of 60 ° C is reached, run engine for a further 15 minutes e) Drain cleaning fluid f) Repeat steps c) and d) g) Flush cooling system. To this effect h) Replace drain plug by drain plug with a bore of 8 mm dia i) Fill cooling system with hot water k) Run engine at idle for 30 minutes. At the same time continuously replenish the water leaking from the bore in drain plug by adding fresh water Repair water pump only now. Thereafter, fill the cooling system with approved cooling fluid. See Publication “Fuels, Lubricants ...”. Note: Only sediments and suspended particles can be removed by this cleaning method.

If corrosion and lime deposits are found, proceed according to the following section: 59