24. SERVICE PROCEDURE 24.8.4 LUBRICATING PARKING BRAKE WARNING When carrying out maintenance, raise the brake oil pressure sufficiently to prevent the parking brake from being automatically applied. In addition, hang a warning tag that can be seen clearly to prevent any other person from operating the parking brake switch. Do not get any oil or grease on the brake disc or pad surface. 1. Stop the machine in a flat place and put the blocks under the tires to prevent the machine from moving. 2. Raise the dump body and secure it in position with the body pivot pin. 3.
Before starting operations, raise the brake oil pressure sufficiently to prevent the parking brake from being automatically applied, and check that the brake pressure caution lamp is not lighted up. 4. Release the parking brake and stop the engine. 5. Using the grease pump, pump in grease through fittings 1 , 2 , 4 , and 5 (4 places) on the parking brake body and fittings 3 and 6 (2 places) on the slack adjuster. NOTICE Do not use air pressure or oil pressure to carry out high-pressure greasing. 6. After completing the greasing, remove fittings 1 and 4 . If grease comes out, wipe it off.
REMARK Removing fittings 1 and 4 makes it possible to release the abnormal internal pressure caused by over-supply of grease. 7. When no more grease comes out, install fittings 1 and 4 . 8. Check that the parking brake works properly. If there is any abnormality in the operation of the parking brake or the brake does not provide the proper braking effect, please contact your Komatsu distributor for adjustment. 3-71