Komatsu — 24.9 EVERY 2000 HOURS SERVICE

24. SERVICE PROCEDURE 8. Remove mounting bolts 5 of the 3 filter covers 4 at the top of the tank, then remove the covers. When doing this, the cover may fly off because of the force of spring 6 , so keep the cover pushed down while removing the bolts. 9. Remove spring 6 and bypass valve 7 , then remove element 8 . 10. Check that there is no foreign matter inside the tank before cleaning it. 11. Install a new element, then install bypass valve 7 , spring 6 , and cover 4 . If the O-ring of the cover is damaged or deteriorated, replace it with a new part. 12. When installing the cover bolts, push down the cover and tighten the bolts evenly. 13.

Add engine oil through oil filler port F to the specified level, then install air bleed plug 1 on filter case. The cap of the hydraulic tank remains removing, until the air bleeding of the piston pump finishes. For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 14. Check that the hydraulic oil is at the standard level. For details, see “24.5 EVERY 100 HOUR SERVICE”. 15. Loosen plug 9 on top of the tube at the suction side of the piston pump. There is one plug for each pump, so loosen all plugs (3 places). 16. Continue until oil flows out from plug 9 (3 places). After the air has been completely bled, tighten plug 9 (3 places).

After that, in order to fill the inside of the pump with the hydraulic oil, leave it is for 10 minutes. 3-76