Komatsu — 24.9 EVERY 2000 HOURS SERVICE

24. SERVICE PROCEDURE 24.9.2 CLEAN HYDRAULIC TANK STRAINER When changing the oil in the hydraulic tank, drain the oil from the tank and clean the strainer. 1. Loosen bolts 1 and 3 , then remove covers 2 and 4 . 2. Loosen bolt 5 , remove strainer cover 6 , then remove strainer 8 together with spring 7 . 3. Remove any dirt from strainer 8 , then wash in clean light oil or flushing oil. If strainer 8 is broken, replace it with a new part. 4. Install spring 7 , strainer 8 , and cover 6 . When doing this, look through the mounting hole of cover 4 to check that the strainer guide pin is fitted in the guide hole.

When installing cover 6 , coat the thread of bolt 5 with thread tightener (LT-2) to prevent it from coming loose. If bolt 5 becomes loose and drops out, it will be sucked into the piston pump and will damage the pump. Tightening torque of bolt 5 : 88 ± 34.3 N·m (9 ± 3.5 kgf·m, 65 ± 25.3 lbft) 5. Install covers 2 and 4 . Replace the O-rings of the covers with new parts. 3-78