24. SERVICE PROCEDURE 24.9.3 REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before chang- ing the oil. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully. 1. Remove the cap of oil filler F . 2. Remove the snap ring on breather 1 , then remove the breather cap. 3. Replace the filter element with a new part, then install the cap and snap ring. 4. Tighten the cap of oil filler F . REMARK It is possible to replace the element with the breather installed in the tank.
However, if the breather is removed, do not wrap the taper thread of the breather with seal tape when assembling again, and be careful not to tighten too much. 3-79