29. HANDLING JOYSTICK STEERING SYSTEM 29.3 OPERATION METHOD OF JOYSTICK STEERING SYSTEM ¤ CAUTION When operation with joystick lever 1 , always adjust the angle of the steering wheel so that it is possible to see the F-N-R display (LED) on the left of the machine monitor. The illuminance of the LED changes as the small lamp is turned ON and OFF. F-N-R is also displayed on the two locations of the main monitor shown at right, synchronized with the F-N-R display of the LED. While F or R is displayed, the speed range is indicated on the N- portion 1. Adjustment of steering wheel ¤ WARNING Stop the machine before adjusting the angle of the steering wheel.
This lever allows the steering column to be tilted forward or backward. Pull the lever up and move the steering wheel to the desired position. Then push the lever down to lock the steering wheel in position. Range of adjustment: 125 mm (4.9 in) (stepless) 2. Sit on the operator’s seat and pull up lever 3 to unlock the joystick console, then slide the latter from the rear position to the forward stroke end, then lock it securely. Under this condition, safety switch 4 is turned on. Adjust joystick 1 to the angle for easy operation with console box adjustment lever 2 . (See “29.5 ADJUSTMENT OF JOYSTICK CONSOLE”.) 3. Fasten the seat belt. 4.
Confirm that joystick 1 operates normally and forward/reverse lever 7 of the transmission is a the neutral position and the periphery of the vehicle is safe. Then, start the engine. 5. Turn on joystick ON/OFF switch 8 . If the directional lever 7 of the transmission has been at F or R position, the transmission is set to N (Neutral) by the neutral interlock mechanism. In this case, return the directional lever 7 of the transmission to the N (Neutral) position, then start travel forward or in reverse. 5-12