29. HANDLING JOYSTICK STEERING SYSTEM 2. Work with joystick and steering wheel ¤ CAUTION Because of the neutral interlock circuit, the forward and reverse directions of the transmission cannot be changed over (from forward/reverse lever to F/N/R button of the joystick when the joystick ON/OFF switch is on, and from F/N/R button of the joystick to forward/reverse lever when the joystick ON/OFF switch is off) if the forward/reverse lever and F/N/R button of the joystick are not in the neutral positions respectively. Use the joystick or steering wheel according to the type of work.
1) Steering with joystick Joystick is suitable for continuous loading work in a wide job site with a relatively long cycle time. Since the stroke of the joystick is short and the resistance is low, the operator is less fatigued even if he operates the machine continuously. 2) Steering with steering wheel Since the operator can drive fast on a straight course and can control finely with the steering wheel, he can work efficiently with it when moving among job sites and in load-and-carry operations. The steering wheel is also suitable for works of short cycle time since the operator can hold the upper part of his body when changing the moving direction. 3.
The joystick console can be slid for the ease of riding and getting off the vehicle. It is possible to tilt the console box to position C ( ) and to slide the console to position D ( e ) by operating lever 3 . For details of adjusting the joystick console, see “29.5 ADJUST- MENT OF JOYSTICK CONSOLE”. ¤ WARNING When riding and getting off the cab, be sure to slide the joystick console backward. If the console is slid backward, safety switch 4 is turned off and operation of the joystick is automatically turned off. To prevent unexpected turning of the vehicle by misoperation of the joystick while the engine is running, be sure to slide the joystick console backward. 5-11