Komatsu — 36.2 METHOD OF OPERATING MULTI MONITORING SYSTEM

36. HANDLING MULTI MONITORING SYSTEM 5) When the check is completed and GOOD is displayed for each item, the display changes to troubleshooting for the oil maintenance 6) The specified maintenance time and the time remaining to the specified time are displayed for 4 items: engine, trans- mission, work equipment, axle. The display then changes to the filter maintenance display. 7) The specified maintenance time and the time remaining to the specified time are displayed for 4 items: engine, trans- mission, work equipment, fuel. The display then changes to the pin maintenance 1 display. 8) The specified maintenance time and the time remaining to the specified time are displayed for 3 items:

axle pivot pin, work equipment pin, steering cylinder pin. The display then changes to the pin maintenance 2 display. 9) The specified maintenance time and the time remaining to the specified time are displayed for 3 items: center hinge pin, drive shaft, center support. REMARK The display for the remaining time to pin maintenance always shows the specified value. For machines equipped with the auto- greasing system, only the drive shaft item is used for pin mainte- nance 1 and 2. The other items are not needed. 10) After completion of the check before starting, the START OK display is given. 5-64