Komatsu — 36.5 HANDLING PRINTER

36. HANDLING MULTI MONITORING SYSTEM 36.5.3 SELF TEST If the power is turned on when the FEED switch is being pressed, the printer will enter the self-test mode, so check the condition of the print out. The printer will print out the internal CG ROM data. In JIS 6220 mode, level 1 and level 2 Japanese characters will be printed out. 36.5.4 METHOD OF SETTING PRINTER PAPER When first using the printer, or when the PAPER END lamp lights up, or when a red mark starts to appear on both sides of the paper, set a new roll of paper as follows. 1. Press the “Press to open” button, lift the top cover, and remove it to the rear. 2. Insert a new roll of paper. Always use the specified paper.

Thermal paper: 421-T32-2290 (Nihon Premex or Jujo Paper) (Type: TP112-25CJ3 or equivalent) Outside diameter of paper role: Max. 50 ш Inside diameter of paper role: Min. 12 ш REMARK The paper has a front and back, so be careful to set it as shown in the diagram. 3. Set the lever to the platen lever to the OPEN position. When this happens, the error lamp will light up. Set the paper as shown in the diagram. 4. When the paper comes out from the printer, set the platen lever to the CLOSED position. The error lamp will go out. 5. Press the FEED switch to feed the paper. 6. Pass the paper through the paper outlet port in the case cover. 7.

Fit the front of the cover to the printer, and push it to the front until there is a click. 5-99