36. HANDLING MULTI MONITORING SYSTEM 36.6 PRECAUTIONS WHEN HANDLING MULTI MONITORING SYSTEM CAUTION Do not push the liquid crystal panel strongly or allow any- thing to hit it. Do not let water get on the equipment. If water gets inside, it will cause failure. Never disassemble the equipment. Some parts are at high voltage, so it is dangerous to touch any internal parts. Never use benzene, thinner, or chemically treated cloth to clean the equipment. Such substances will attack the surface of the panel. NOTICE Be careful of high temperatures High temperature will have an adverse effect on the equipment.
When the machine has been left in the open for a long time in summer, drive the machine for a short time before using this equipment. Be careful not to discharge the battery. If the equipment is used for a long time with the engine turned off, there is danger that there will be excessive discharge of the battery. Run the engine at idling. Cleaning panel surface When removing the dirt from the panel, use a soft cloth (silicon cloth, etc.). If the panel is extremely dirty, wipe with a small amount of neutral cleaning agent. The following are not failures The screen movement is slow In extremely cold areas where the temperature goes below 0°C, the movement of the screen may become slower.
However, the speed will return when the temperature returns to the service temperature range (0°C to +55°C). There are small black spots and bright spots on the liquid crystal panel, but this is a characteristic of liquid crystal. Image remains The display screen may remain, but this is a characteristic of liquid crystal. 5-100