38. HANDLING OF ELECTRICAL WORK EQUIPMENT CONTROL LEVERS 38.2 WORK EQUIPMENT CONTROL LEVERS 1. SAFETY LOCK LEVER WARNING Before standing up from the operator’s seat, set the safety lock lever securely to the LOCK position. If the safety lock lever is not at the LOCK position, and work equipment control lever A is touched by mistake, it may lead to serious accident If the safety lock lever is not placed securely at the LOCK position, the work equipment control levers may move, and this may lead to a serious accident or personal injury. Check that the lever is in the position shown in the diagram.
When pulling up or pushing down the safety lock lever, be careful not to touch work equipment control levers A . This safety lock lever is used to lock the work equipment control levers. Push the lever down to apply the lock. REMARK This safety lock lever electrically locks the hydraulic circuit from the work equipment, so if it is kept at the LOCK position, the work equipment does not move even when work equipment control lever A is operated. 2. BUCKET CONTROL LEVER This lever operate the bucket. Position a :
TILT When the bucket control lever is pulled further from the TILT position, the lever is stopped in this position until the bucket reaches the pre-set position of the bucket positioner, and the lever is returned to the HOLD posi- tion. Position b : HOLD The bucket is kept in the same position. Position c : DUMP 5-107