Komatsu — 38.4 OPERATION OF WORK EQUIPMENT

38. HANDLING OF ELECTRICAL WORK EQUIPMENT CONTROL LEVERS 38.4 OPERATION OF WORK EQUIPMENT Lift arm control lever 1 and bucket control lever 2 can be used to operate the lift and bucket as follows. LIFT ARM CONTROL LEVER Position a : RASISE Position b : HOLD The lift arm is kept in the same position. Position c : LOWER Position d : FLOAT The lift arm move freely under external force. When the lift arm control lever is pulled further from the RAISE position, the lever is stopped in this position until the lift arm reaches the preset position of the kick-out, and the lever is returned to the HOLD position. NOTICE Do not use the FLOAT position when lowering the bucket.

BUCKET CONTROL LEVER Position a : TILT Position b : HOLD The bucket is kept in the same position. Position c : DUMP When the bucket control lever is pulled further from the TILT position, the lever is stopped in this position until the bucket reaches the pre-set position of the bucket positioner, and the lever is re- turned to the HOLD position. 5-110