Komatsu — 38.3 SWITCHES

38. HANDLING OF ELECTRICAL WORK EQUIPMENT CONTROL LEVERS 38.3 SWITCHES 1. KICKDOWN SWITCH When the speed control lever is in 2nd, and the switch at the top of the knob of the lift arm control lever is pressed, the gear will shift down to 1 st. This switch is used to increase the drawbar pull in digging operation. REMARK To cancel the kick down switch, move the directional lever to REVERSE or NEUTRAL, or move the speed control lever to any position except 2nd. It is also possible to cancel the kickdown switch by operating the parking brake switch or by turning the starting switch OFF. 2.

HOLD SWITCH To fix the gear shift range when using automatic gear shifting, press the switch at the side of lift arm control lever knob. The speed range displayed on transmission indicator on the main monitor is fixed, and HOLD display lights up. If the switch is pressed again, the HOLD function is canceled and display goes out. Use this function to set to the desired speed range when traveling uphill or downhill, or when carrying out grading. REMARK If the gear shifting operation is carried out with the gear shift lever, it is possible to shift down or shift up the fixed speed range. 5-109