Maintenance section Cooling System Specifications Coolant Information Check the specific gravity of the coolant solution frequently in cold weather to ensure adequate protection. Clean the cooling system if it is contaminated, if the engine overheats or if foaming is observed in the radiator. Old coolant should be drained, the system cleaned and new coolant added every 2000 service hours or yearly. Refer to topic, “Cooling System-Clean, Change” in every 2000 service hours or yearly section. Filling at over 20 liters (5 U.S. gallons) per minute can cause air pockets in the cooling system.
After draining and refilling the cooling system, operate the engine with the radiator cap removed until the coolant reaches normal operating temperature and the coolant level stabilizes. Add coolant as necessary to fill the system to the proper level. Never operate without a thermostat in the cooling system. Cooling system problems can arise without a thermostat. NOTE : The following information is generic and valid for lift trucks. Engine operating temperatures have increased to improve engine efficiency. This means proper cool ing system maintenance is especially important.
Overheating, overcooling, pitting, cavitation erosion, cracked heads, piston seizures, and plugged radiators are classic cooling system failures. In fact, coolant is as important as the quality of fuel and lubricating oil. NOTICE DOOSAN recommends that the coolant mixture contain a minimum of 30% antifreeze or equivalent. Never add coolant to an overheated engine, engine damage can result. Allow the engine to cool first. All water is corrosive at engine operating temperature. The cooling system should be protected with a 3 to 6% concentration of liquid supplemental coolant additive at all times, regardless of the concentration of antifreeze.
Excessive supplemental coolant additive greater than the recommended 6%, together with concen- tration of antifreeze greater than 65% can cause deposits to form and can result in radiator tube blockage, overheating, and/or water pump seal damage. If the machine is to be stored in, or shipped to, an area with freezing temperatures, the cooling system must be protected to the lowest expected outside (ambient) temperature. The engine cooling system is normally protected to –28°C (–20°F) with antifreeze, when shipped from the factory unless special requirements are defined. 98