Maintenance section Inspect Engine for Fluid Leaks Coolant Level - Check 1. Start the engine and allow it to reach operating temperatures. W ARN I N G 2. Turn the engine off. At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure. Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury. 1. Observe the coolant level with engine cold. Maintain coolant level to the proper line on expansion bottle.
If the expansion bottle has no coolant, it will be necessary to check coolant at the radiator filler neck. 3. Inspect the entire engine for oil and/or coolant leaks. 4. Repair as necessary before continuing. Engine Oil Level – Check 1. Raise the hood and seat assembly. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. W ARN I N G 2. Measure the crankcase oil level. Maintain the level to FULL mark on the dip stick. 2. Remove the radiator cap. Fill radiator to the top of the filler neck. Inspect radiator cap. Replace if damaged. Install the radiator cap. 3. Start and run the engine to stabilize the coolant level in the filler neck.
If low add coolant until it reaches the top of the filler neck. Install the radiator cap. Observe coolant level in the expansion bottle. If necessary, add coolant to bring the coolant to the appropriate line on the expansion bottle. 4. Stop the engine. 5. Inspect the cooling system for leaks, hose cracks or loose connections. 112