Maintenance section Mast Channels - Lubricate Transmission Oil Level - Check The channels on the roller-type mast require a break-in period. Apply a light film of lubricant on the channels where the rollers ride. This will prevent metal peel until the rollers set a pattern. Checking Oil Level Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. 1. Start and operate the lift truck until the engine reaches normal operating temperature. 2. Park the lift truck level with the forks lowered, parking brake applied and the transmission con- trols in NEUTRAL. 3.
With the service brake applied and the engine at low idle, shift the directional control lever to for- ward and then to reverse, to fill the clutches. 4. Shift the direction control lever to the NEUTRAL position. 5. Open the floor plate. 6. Remove the dip stick. Observe the oil level. 7. Maintain the oil level between the MIN and MAX marks on the dip stick. 114 WARNING