Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section First 50-100 Service Hours or a Week You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Parking Brake - Test, Adjust Transmission Oil & Strainer - Change, Clean NOTE : Be sure area around the lift truck is clear of personnel and obstructions. Test Operation Power Shift Transaxle(PTA18) 1. Drive the lift truck, with a capacity load, forward up a 15% incline [a slope that increases 1.5 meters in 10 meters (1.5 ft increase in 10 ft)]. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. 2.

Halfway up the incline, stop the lift truck with the service brake. Park the lift truck level, with the forks lowered, park- ing brake engaged, transmission in NEUTRAL and the engine stopped. Component is shown removed from the lift truck for illustrative purposes. 1. Remove drain plug (1). Allow the oil to drain. Check O-ring seal and replace if necessary. Remove the strainer. 3. Engage the parking brake. Slowly release the service brake. IPMO060I 2. Wash the strainer in clean, nonflammable sol- vent and dry it. Install the strainer, and the drain plug. 3. Remove the filler cap. Fill the compartment with oil. See “Refill Capacities”. Install the dip stick/filler cap. 4.

The parking brake should hold the lift truck. If the lift truck starts to move, immediately apply the service brakes. Have the parking brake adjusted. 4. Start the engine. 5. With the service brake applied and engine at low idle, shift the transmission to forward and reverse to fill the clutches. 115 WARNING