Maintenance section 6. Shift the transmission into NEUTRAL. Engage the parking brake. Drive Axle Oil - Change 7. Remove the dip stick. Observe the oil level. Park the lift truck on a level surface. Apply the parking brake. Place the directional control lever in NEUTRAL. 1. Raise the carriage high enough to access the drain plug and level/fill plug. 8. Maintain the oil level between the MIN and MAX marks on the dip stick. 9. Check for oil leaks at the strainer and drain plug. 10. Stop the engine. Install the floor plate. 2. Block the bottom of the mast with a block of wood to hold the carriage in the raised position. 3. Turn the ignition switch OFF. 4.
Place an appropriate container under the axle to catch the oil as it drains. Remove the drain plug and the level/fill plug. 5. Allow the oil to drain completely out. Discard the old oil according to federal, state, and local regulations. 6. Clean and reinstall the drain plug. 7. Add sufficient fresh oil through the level/fill opening until it reaches the bottom of the hole. See the section Lubricant Viscosities and Refill Capacities for the type and amount of oil to use. 116