Maintenance section Every 250 Service Hours or Monthly You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Air Intake System - Check, Clean 3. Clean and inspect the element or replace with a new element. See topic, “Cleaning Primary Filter Element”. Servicing Filter Element 4. Clean the inside of air cleaner housing and the cover. Inspect all connections between the air cleaner and carburetor. Check intake hose for cracks, damage necessary to prevent leakage. NOTICE Never service filter with the engine running.
Service the air cleaner when the red target in the service indicator stays locked in the visible position with the engine stopped. 1. To service the air cleaner, raise the hood and seat assembly. Make certain the support cylinder securely holds the hood open. Loosen the cover latches and remove the cover. NOTICE Do not allow dirty air to enter the intake hose when cleaning the inside of the cleaner hous- ing. 5. Check the air cleaner housing for loose retain- ing bolts. 6. Reset the air cleaner service indicator. 7. Install the air filter element. 8. Install the cover and tighten the cover latches. 9. Start the engine and observe the position of the indicator.
If the indicator shows RED after the installation of the primary element, install another clean or a new element or, replace the secondary element. See topic, “Air Intake System - Change” in Every 1000 Service Hours or 6 months section. 2. Rotate the element slightly to separate it from its base and remove it from the air cleaner housing. 10. Stop the engine and close the hood and seat assembly. 119