Maintenance section Mast, Carriage, Lift Chains & Attachments - Inspect, Lubricate Steering Mechanism - Check, Lubricate 1. Operate the lift, tilt and attachment controls. Listen for unusual noises. These may indicate a need for repair. 2. Inspect for loose bolts and nuts on the carriage. Remove any debris from the carriage and mast. 3. Inspect the forks and attachments for free operation and damage. Have repairs made if necessary. 1. Lubricate the steer axle king pins, total of four fit- tings. Two on the right side and two on the left side. 2. Lubricate the steering link bearings, total of four fittings. Two on the right side and two on the left side. 4.
Brush a film of oil on all links of the chain. 3. Check for any worn or loose components of the steering mechanism. Remove any debris or trash as required. 5. Raise and lower the carriage a few times to work lubricant into the chain links. NOTICE Lubricate chains more frequently than normal in applications where the lift truck is operating in a atmosphere which could cause corrosion of components or when lift truck must work in rapid lift cycles. 6. Inspect the chain anchors and individual links for wear, loose pins or cracked leaves. 122