Maintenance section Every 500 Service Hours or 3 Months You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Belts - Check, Adjust Tilt Cylinders - Check, Adjust, Lubricate Typical Example 1. Check the condition and adjustment of the belt. Correct adjustment allows 12mm (0.47 inch) deflection under 98N(22lb) of force. Chassis Pivot Eyebolts - Lubricate 1. Remove floor plates. 2. Lubricate two fittings for the pivot eyebolts, one on each tilt cylinder. Typical Example 3. Check the pivot eye pins for loose retainer bolts and wear.
Mast Pivot Eyes-Lubricate NOTICE Failure to loosen the alternator mounting bolt will cause excessive stress and break the alter- nator mounting ear. 1. Lubricate two fittings for the mast pivot eyes, one on each side of the mast. 2. To adjust the alternator drive belt, loosen adjusting bracket bolt and mounting bolt. Move the alternator in or out as required. Tighten bolts. 2. Check the pivot eye pins for loose retainer bolts and wear. 125