Maintenance section Cylinder Rod Extension-Adjust Mast Hinge Pin - Lubricate NOTE : The following description is for forward tilt. For cylinder rod back tilt, the collar should be stationary by the tilt eye. If it is not, the O-ring inside the collar may need to be replaced. To adjust back tilt, spacers must be added or removed. 1. Lower the forks and tilt the mast forward. 2. Lubricate the two fittings for the mast hinge pins, one on each side of the mast. Crosshead Roller - Inspect 1. Check to make sure the tilt cylinders extend and retract evenly. 2.
If one cylinder continues to move after the other cylinder has stopped in full forward or backward tilt, an adjustment must be made to one cylinder. 1. Operate the mast through a lift cycle. Watch the chains move over the crosshead rollers. Make sure the chain is tracking over the rollers properly. 3. To adjust the cylinder rod extension, move the spacer to the rear and loosen the pinch bolt on the clevis. 4. Turn the cylinder rod in or out of the clevis to obtain the proper adjustment. Turning the rod into the clevis shortens the stroke. Turning the rod out of the clevis lengthens the stroke. 5. Tighten the pinch bolts to a torque of 95±15 N•m (70±10 lb•ft).
Check the cylinder rods again for even travel. Typical Example 2. Check for damaged crosshead rollers, guards and retainer rings. 126