Maintenance section Inspect Vacuum Lines and Fittings (G420F(E) Engine Only) Inspect Electrical System (G420F(E) Engine Only) 1. Visually inspect vacuum lines and fittings for physical damage such as bittleness, cracks and kinks. Repair/replace as required. 2. Slovent or oil damage may cause vacuum lines to become soft resulting in a collapsed line while the engine is running. 3. If abnormally soft lines are detected, replace as necessary. 1. Check for loose, dirty or damaged connectors and wires on the harness including: Fuel lock- off, TMAP sensor, O2 sensor, Electronic throttle, Control Relays, Fuel Trim Valve, Foot Pedal, and crank sensor. 2. Repair and/or replace as necessary.
2 1 (1) Fuel Trim Valve(FTV) (2) Vacuum lines Fuel Trim Valve(FTV) Inspection (G420F(E) Engine Only) 1. Visually inspect the Fuel trim valve for abrasions or cracking. Replace as necessary. 2. To ensure the valve is not leaking a blow-by test can be performed. 3. With the engine off, disconnect the electrical connector to the FTV. 4. Disconnect the vacuum lines form the FTV to the pressure regulator/converter, at the converter’s tee connection. 5. Lightly blow through the vacuum line connected to the FTV. Air should not pass through the FTV when de-energized. If air leaks past the FTV when de-energized replace replace the FTV. 128