Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section Carriage Chain Adjustment Make sure that carriage height is correct. If correct, adjust the chain for equal tension. If not, adjust the chain for correct carriage height by adjusting anchor nuts(1),(2). NOTE : See the previous section, “Carriage Roller Extrusion” in “When Required”. for proper height of carriage. 1. Fully lower the carriage and tilt mast forward or lift the carriage and put blocks under the carriage to release the tension from the lift chains. 4. Set the mast vertical and raise the carriage and check equal chain tension. If not equal, repeat the same procedure as step 1 through step 3. 5. Put LOCTITE No.

242 Tread lock on the threads of the anchor nuts(1),(2) after the adjustment is completed. Mast Chain Adjustment - FF,FFT Mast 2. Loosen nut(1) and adjust nut(2) to get proper distance from bottom of inner upright to the bottom of carriage bearing. Typical example for carriage chain of STD mast Typical example for carriage chain of FF,FFT mast 3. Make adjustment anchor nut(1),(2) for equal chain tension. Typical example for FF mast Typical example for FFT mast Make sure that mast height is correct. If correct, adjust chain for equal tension. If not, adjust mast chain for correct mast height by adjusting anchor nuts(3),(4). NOTE :

See the previous section, “Carriage Roller Extrusion” in “When Required”. for proper inner mast height. 1. Lift the inner mast and put blocks under the inner mast to release the tension from the lift chains. 2. Loosen nut(3) and adjust nut(4) to make inner mast rail flush with outer mast rail bottom. 131