Maintenance section Lift Chains - Test, Check, Adjust Check for Equal Tension Lift Chain Wear Test Lift the carriage and the mast high enough for get- ting tension on lift chains. Check the chains, and make sure the tension is the same. Lift chains are required to check for equal tension about every 1,000 service hours or 6 months. Personal injury can be caused by sudden movement of the mast and carriage. Keep hands and feet clear of any parts that can move. Lift Chain Adjustment Inspect the part of the chain that is normally operated over the cross head roller. When the chain bends over the roller, the movement of the parts against each other causes wear.
Inspect to be sure that chain link pins do not extend outside of the link hole. If any single link pin is extended beyond its connecting corresponding link, it should be suspected of being broken inside of its link hole. Lift chains are required to check for wear about every 1,000 service hours or 6 months. Chain wear test is a measurement of wear of the chain links and pins. Take the following steps to check chain wear. 1. Lift the mast and carriage enough for getting tension on lift chains. 2. Measure precisely ten links of chain distance at the center of pins in millimeter.
W ARN I N G Typical example for carriage equal tension If the tension is not the same on both chains, take the procedure as follows. NOTE : If carriage height is not correct, make adjustments by following procedures. 4. If the chain wear rate is 2% or more, replace the lift chain. 3. Calculate chain wear rate*. *Chain wear rate (%) = Actual measurement - Pitch** X 10 Pitch** X 100 **Chain Pitch for GC15/18S-5, GC20SC-5 = 15.88mm(0.63 in) X 100 130