Maintenance section Every 2000 Service Hours or Yearly You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Steer Wheel Bearings - Repack 11. Install the inner bearing. 1. Raise the steer wheels off the ground. Block the lift truck up with blocking under the frame and steer axle. 12. Install the wheel assembly on the steering knuckle. 13. Install the outer wheel bearing. 14. Install the flat washer, lockwasher and locknut. 15. Tighten the locknut to 135 N m (100 lb ft), while turning wheel hub to seat the bearing. 16. Loosen the locknut. Torque the locknut to 50 N m (37 lb ft).
Bend the lockwasher tang to secure lock-nut. 17. Install the hub cap. 18. Raise the lift truck and remove the blocking. Lower the lift truck to the ground. 2. Remove the hub cap. 3. Straighten the lockwasher tangs. 4. Remove the locknut, lockwasher and flat washer . 6. Remove the wheel assembly. 5. Remove the outer wheel bearing. 7. Examine the seal for damage and wear. Replace the seal, if necessary. 9. Clean and lubricate the steering knuckle. 8. Remove the inner bearing. 10. Repack the inner and outer bearings. 136