Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section Fuel Filter (LP - Gas Engine Only) Testing Fuel Lock-off Operation (LP-Gas Engine Only) Disassembly 1. Start engine. 2. Locate the electrical connector for the fuel lock 3. Disconnect the electrical connector. 4. The engine should run out of fuel and stop within a short period of time. 1 4 5 2 3 6 7 5. Turn the ignition key switch off and re-connect the fuel lock-off connector. 1. Check bottom cover O-ring seal (6) for damage. Replace if necessary. 2. Re-assemble the filter assembly aligning the scribe lines on the top and bottom covers. 3. Install the cover retaining screws, tightening the screws in an opposite sequence across the cover. 4.

Open the fuel valve by slowly turning the valve counterclockwise. 5. Crank the engine several revolutions to open the fuel lock-off. DO NOT START THE ENGINE. Turn the ignition key switch to the off position. 6. Check the filter housing, fuel lines and fittings for leaks. Repair as necessary. NOTE: The length of time the engine runs on trapped fuel vapor increases with any increase in distance between the fuel lock- off and the pressure regulator/converter. 1 2 3 (1) LP fuel lock-off (2) Regulator / couverter (3) Fuel Trim valve (FTV) 135