Maintenance section Every 2500 Service Hours or 15 Months You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Hydraulic Oil - Change, Check, Clean 5. Start the engine and operate the hydraulic con- trols, and the steering system, through a few cycles to fill the lines. Look for oil leaks. 6. Stop the engine and check the oil level. With all cylinders retracted, maintain the oil level to the FULL mark on the breather/dip stick. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
Park the lift truck level with the forks lowered, park- ing brake engaged, transmission in NEUTRAL and the engine stopped. 1. Remove the hydraulic tank drain plug. Allow the oil to drain. Clean and install the plug. 2. Remove the breather/dip stick. 3. Remove the strainer. Wash the breather and strainer in clean, nonflammable solvent and dry 4. Install the strainer. Fill the hydraulic tank. See topic Refill Capacities. Install the breather/dip stick. 141 WARNING